Xycd60 Manual -

To configure the XY-CD60, follow these steps to set the upper ( UP ) and lower ( dn ) voltage limits:

Adds a delay (in seconds) between reaching the activation voltage and the relay actually closing.

The is a highly versatile, dual-mode battery charge and discharge controller module designed for DC systems operating between 6V and 60V . Commonly utilized in solar power storage, DIY electronics projects, and custom battery management systems (BMS), this module acts as an intelligent voltage-controlled switch. It is vital to understand that the xycd60 manual

XY-CD60 Solar Battery Charge Controller Module - RoboFactory

Long press the SET button for 5 seconds to save and exit. Parameters Defined UP (Upper Limit): High voltage threshold. dn (Lower Limit): Low voltage threshold. To configure the XY-CD60, follow these steps to

You can set a delay (0-999 seconds) between cycles, which is useful for allowing batteries to stabilize or "rest" between charge and discharge phases.

| Mode/Function | Action | Feedback | Notes | | :--- | :--- | :--- | :--- | | | Fully press the tail switch. | Light turns on. | Use side switch for brightness adjustment. | | Off | Fully press the tail switch again. | Light turns off. | The last used illumination mode is memorized. | | Tactical Momentary | Half-press the tail switch. | Light turns on only while pressed. | Release to turn off. | | Change Brightness | Click the side switch. | Light cycles through brightness modes. | Order: Micro → Low → Middle → High → Ultra Bright. | | Strobe/SOS | Press and hold the side switch for 1.5 seconds. | Enters Strobe mode. | Click side switch to change: Strobe → SOS → Slow Flash. Press and hold 1.5s again to exit. | | Instant Turbo | Quickly double-click the side switch. | Activates ultra-bright illumination. | Directly accesses the highest brightness mode from any state. | It is vital to understand that the XY-CD60

| Battery Type / Voltage | Upper Limit (UP, overcharge) | Lower Limit (dn, cut‑off) | | :--------------------- | :--------------------------- | :------------------------- | | 12V Lead‑Acid (AGM/GEL) | 14.4 V – 14.7 V | 10.5 V – 11.0 V | | 12V LiFePO₄ | 14.4 V – 14.6 V | 10.0 V – 11.0 V | | 24V Lead‑Acid | 28.8 V – 29.4 V | 21.0 V – 22.0 V | | 48V Lead‑Acid | 57.6 V – 58.8 V | 42.0 V – 44.0 V |

Top tips from the manual (practical takeaways)

Adjust the L-P setting to OFF to keep it lit permanently.

The is a versatile digital battery charge and discharge control module designed to protect battery packs, particularly lithium-ion, LiFePO4, and lead-acid batteries, from overcharging and over-discharging. It features a digital display, relay control, and adjustable voltage settings. This article serves as a comprehensive guide, functioning as an XY-CD60 manual to help you configure, install, and operate this module effectively . 1. Product Overview and Technical Specifications