Sp Flash Tool Stuck On //free\\ Download Da 100 Jun 2026
Let me know your and chipset (e.g., MT6739, Helio G85) – I can give you device-specific settings.
The phone has Secure Boot enabled (modern MTK devices), requiring a signed DA file. Drivers Issue: Missing or outdated MTK USB VCOM drivers.
Using a generic DA file on a secured or specific processor variant often results in a 100% hang. Working with SP Flash Tool - GeeksforGeeks
If your SP Flash Tool is stuck on "Download DA 100%", you are not alone. This is one of the most common errors when flashing MediaTek (MTK) devices. sp flash tool stuck on download da 100
:
Download a trusted, open-source (such as MCT MTK Auth Bypass). Launch the bypass utility and click Bypass .
Change the default speed threshold from to Full Speed . This throttles data alignment over raw USB blocks and rectifies transmission noise on older computer ports. 5. Isolate Hardware Failures (EMMC / UFS Fault) Let me know your and chipset (e
Newer versions of SP Flash Tool drop support for very old legacy MTK chips, while older versions of the tool do not understand the architecture of newer Dimensity or Helio chips.
The device disconnects instantly, rejects the DA file version, or demands a security bypass handshake. Step-by-Step Solutions to Fix the Hang 1. Bypass MediaTek Secure Boot (SLA/DAA)
Some MTK devices require the battery to be 100% disconnected inside the chassis when flashing with certain DA files, while others require a minimum of 50% charge to power the emmc chip during the flash write phase. If your phone has a removable battery, try pulling it out, putting it back in, and flashing without turning the phone on. Using a generic DA file on a secured
Within SP Flash Tool, manually click the button next to Download Agent and map it explicitly to your factory-provided DA file instead of the default software directory. 4. Change Flash Tool Download Speeds
If the progress bar fills to 100% and then hangs without moving to the next stage (yellow bar), try these troubleshooting steps: