Fortigate 30d Factory Reset ^hot^ Full -

Continue holding the button until the Status/Power light begins flashing, usually after 10–20 seconds.

Allow the system to reboot automatically.

The system will immediately prompt you to create a secure, new administrative password. Accessing via CLI Keep your serial console connection open during the reboot.

: bcpb followed immediately by the Serial Number of your FortiGate 30D (e.g., bcpbFGT30DXXXXXXXXX ). Note: Letters in the serial number must be capitalized. fortigate 30d factory reset full

Connect an ethernet cable from your computer to any on the FortiGate 30D. Open a web browser and navigate to https://192.168.1.99 .

Performing a full factory reset on a FortiGate 30D firewall clears all custom configurations, policies, and IP addresses. This process reverts the security appliance back to its original out-of-the-box state.

While the device is powered on, use a paperclip or SIM eject tool to hold down the reset button. Continue holding the button until the Status/Power light

You will be forced to change the password on first web login.

To help you get your FortiGate 30D configured correctly after the reset, let me know:

The Command Line Interface (CLI) is the cleanest and most reliable method to execute a full factory reset. Step 1: Connect to the CLI You can access the CLI using two methods: Accessing via CLI Keep your serial console connection

Ensure the device is powered on and fully booted (the Status LED should be solid or blinking normally).

Note: Some firmware versions show “Reset” under System → Dashboard widgets.

After factory reset, the management IP should be 192.168.1.99 . Ensure your computer's network adapter is configured with an IP in the same subnet (e.g., 192.168.1.100 ). Also verify that no other device on your test network is using 192.168.1.99 .

If you have lost the password and the physical button is disabled, use the console port and the account.