: Enters the specific sub-mode to configure E1 traffic lines.
configure user delete username "old_engineer" exit
| Command | Description | |---------|-------------| | show radio link | Overview of all radio links | | show radio link <id> | Detailed parameters for specific link | | show radio performance | Tx/Rx levels, modulation, bit error rate (BER) | | show radio adaptive modulation | Current and possible modulations | | show radio atpc | Automatic Transmit Power Control status | | show radio xpic | Cross Polarization Interference Cancellation status (for XPIC links) | | radio loopback <id> internal | Internal loopback on radio interface for testing | | radio loopback <id> external | External loopback | | clear radio performance <id> | Reset performance counters |
MINI-LINK supports:
show interface — Lists all physical and logical interfaces with link status (Up/Down). ericsson mini link cli commands
Lists all configured Virtual LANs (VLANs) and their associated port memberships. create vlan name Use code with caution. Provisions a new VLAN on the node.
: Displays the historical system event log, useful for tracking intermittent power drops or cards reboots. Loopback Testing
Always save your changes to permanent memory to prevent data loss during a power cycle.
Changes made in CLI are in "running config" and will be lost after a reboot if you do not use the write command. : Enters the specific sub-mode to configure E1 traffic lines
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
: Enters Privileged Exec Mode (required for configuration changes).
: Displays the active VLAN database, showing VLAN IDs and associated switch ports.
board -list : The screen scrolled. Most slots showed "OK," but the radio unit in Slot 4 was flagged. create vlan name Use code with caution
MINI-LINK-001> enable MINI-LINK-001# configure terminal MINI-LINK-001(config)# hostname Site22_ML MINI-LINK-001(config)# interface eth0 MINI-LINK-001(config-if)# ip address 172.16.1.10/24 MINI-LINK-001(config-if)# no shutdown MINI-LINK-001(config-if)# exit MINI-LINK-001(config)# interface radio0 MINI-LINK-001(config-if-radio)# frequency 18000.000 MINI-LINK-001(config-if-radio)# tx-power 20 MINI-LINK-001(config-if-radio)# modulation adaptive 256qam MINI-LINK-001(config-if-radio)# exit MINI-LINK-001(config)# write memory MINI-LINK-001(config)# end MINI-LINK-001# reboot
These commands help verify the health and hardware inventory of the node:
: Always run a configuration export before updating software or changing routing/VLAN profiles.
: Exports the configuration file securely to a centralized server for disaster recovery purposes. To help customize this guide further, let me know: