Merlin Gerin Multi 9 Ic 2000 P Manual !!top!! 【360p】

The main control unit must be installed inside an electrical switchboard or modular enclosure on a standard 35mm DIN rail. Ensure the environment is dry and falls within the operating temperature range of -10°C to +55°C. 2. Mounting the Photoelectric Cell

: The device is designed for DIN rail installation (standard 18mm modules).

The is a specialized programmable twilight switch within the renowned Multi 9 modular system. Designed to address both domestic and tertiary sectors, it automates lighting control by combining a twilight switch (photocell) with a programmable time switch in a single unit. Its primary function is to control the opening and closing of a lighting circuit based on real-time ambient brightness and a user-defined schedule. The light only turns on when the ambient light level falls below a set threshold and the time program permits activation. This dual-functionality optimizes energy savings and ensures lights operate precisely when needed. Merlin Gerin Multi 9 Ic 2000 P Manual

Ensure power is supplied (230V) and the program is correctly set for the current day/time. 6. Difference between IC 2000P and IC 2000P+

Connect the Phase (Live) wire to the designated L terminal and the Neutral wire to the N terminal. The main control unit must be installed inside

The IC 2000 P system consists of two distinct components that must be installed correctly: the DIN-rail control module and the remote photoelectric cell. 1. Mounting the Control Module

Controls lighting based on both ambient light levels (2–2000 lux) and a pre-programmed schedule. Mounting the Photoelectric Cell : The device is

If you need help tracking down specific technical literature, let me know: Do you need the or a scan?

Remove the cover from the sensor. After roughly 60 to 80 seconds (the switch-off delay), the red LED will turn off, extinguishing the lights. Troubleshooting Guide Potential Cause Recommended Action No power supply to the module. Verify voltage across Terminals 1 and 2 using a multimeter. Lux threshold is set too low. Turn the potentiometer clockwise toward a higher Lux value. Sensor wired incorrectly or broken.

This ensures that years from now, the next electrician won’t have to go through the same search you did today.